ROUSH decal banner

[FordFan]

Our '06 didn't get the "ROUSH" decal treatment on the front or rear window since the silver was unavaliable at the time of build. The dealership (from out of state) recently sent me a set as promised. I was wondering if someone could share the measurement of the space from the top of the windshield down to the top of the decal on the front and on the rear from the bottom of the window up to the bottom of the decal.


Thanks in advance,

[FordFan]

What no one has a tape measure? ........ while your out in the garage this weekend polishing your 1 of 1 or 1 in 25 stage 2, run a tape and share some feedback.

Thanks,

[Rangersfan]

My car is under the cover in the driveway right now. I will get you some measurments before I head out to the Barret-Jackson auction tomorrow. From there on to the Hard Rock Casino

[FordFan]

Have fun at the auction, careful not to scratch your nose at the wrong time..........

[Rangersfan]

I know! My luck, I'll be the proud owner of fully restored chevette or something like that. I can't wait to see how much the Daytona replica goes for. As for your measurements, I measured from the top and the sides. I did not measure from the bottom as the curve of the windshield would make it too hard for you to hit the same spot I did. All measurements are from the OUTSIDE of the rubber seal that goes around the windshield.

1.5 inches from the top - I used the top outer corner of the "R" and "H" as my point

5 inches from each side - measured to the top outer corner of the "R" and "H"

Hope this helps. Try taking the top measurement and running some blue painters tape across the windshield, making sure it's level all the way across. Then you could use that to line it up evenly. Good luck

[snkchmr]

I cut the letters on mine & measured it to fit the curve but this was on an 03

[Scarface]

use plenty of water/baby soap mixture!!! clean the windows, put the decals only in a nice cool area, like your garage. Spray the window (a lot) and peel the decal slowly, spray as you go. Spray the window again, both the decal banner and window should be wet. Apply the banner, you will notice that you can still slide the banner around (because its wet), once its aligned, use a squeegee and remove the water. Have fun.

[FordFan]

Thanks for the tips, I did a "BULLITT" banner on my other car last fall and it worked out great. I used a mystery solution along with a credit card.



Anyone have the back window "Roush" measurement. How far up from the bottom of the glass?

Thanks again,

[Rangersfan]

Can't help you on the rear one, as mine did not come with one, which is fine by me as the wing and side louvres create enough of a blind spot.