 |
|
|
|
            |
|
||||
|
||||
|
||||
05-01-2003, 10:04 AM
|
||||
|
||||
|
New stuff on the way
Ok I just got a call from Vortech about the bower I sent the to check out. They said they are going to replace bearings and seals(normal) and everything else looks good. So Im going to get an S-trim and aftercooler, msd ignition, 87mm mas air, 30# injectors and some other little stuff. Hopefully within a week I'll have it back here and ready to install. Weakest 4.6? Not anymore
 Im planning on running 10-12 psi untill the Cobra motor w forged internals goes in. BTW does anyone know a good shop to install and tune at in So Cal? 
|
|
05-01-2003, 11:44 AM
|
||||
|
||||
|
Very nice...only one I know off the top of my head is the guy that just posted his SHM aluminum 4v block with 03 cobra stuff on it. He's a diablo/chip tuner and SHM distributor in San Diego I think.
__________________
2003 SB Roush Cobra - Ford built / Roush prototyped & perfected Griggs in-floor SFCs, MM coil-overs, and a few other tweaks . . . Picture gallery - On the track
|
|
05-01-2003, 11:30 PM
|
||||
|
||||
|
Re: New stuff on the way
Quote:
Maybe the fnsweet garage for the install ?
|
|
05-02-2003, 12:21 PM
|
|||
|
|||
|
have you done the headswap? Please tell me you have... or else you have 60 rwhp just waiting to be unleashed for $1200
-Ryan
__________________
RIP benjamin underwood, also known as CCDemon. 11-19-2002 " Look! A Taxi Roush! " - CCDemon
|
|
05-02-2003, 10:48 PM
|
||||
|
||||
|
Its a 97 Cobra. I got it from a guy who has a 97 Cobra and had that motor as a spare that he was planning to do forged internals on. He never got around to it and wanted to get rid of it cheap. When its built and in the car i want to run a lot of boost on it.
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
?
Linear Mode
