 |
|
|
|
            |
|
||||
|
||||
|
||||
07-08-2003, 07:10 PM
|
|||
|
|||
|
Car won't run after intake install
I got the 3 piece intake installed and the car started okay cold and ran. After I turn the car off it will restart but won't idle and just dies. If I disconnect the battery and leave it for half an hour then I can start it and it idles until I turn it off again then it won't idle when restarted.
Any ideas? Richard. 
|
|
07-09-2003, 03:06 AM
|
||||
|
||||
|
I would also recommend checking the MAF was not damaged and the connector is secure. Try replugging the connector. The computer may be thinking it's getting less air and not providing enough fuel to stay lit.
|
|
07-09-2003, 07:12 AM
|
||||
|
||||
|
Sounds like an air leak to me. Make sure everything fits right. jim
__________________
#1 2001 One of a Kind 6 Speed - ROUSH Stage 3 Convert #01-019 Color: L2 Blue/Tan/Tan / ? RWHP AT 6000 RPM 6 PSI 380 TUNE/ ? RWTQ AT 3200 RPM 6 PSI 380 TUNE C&L Mass Air / C&L Intake Tube / Magnaflow Catted X Pipe / Roush Shorties / Exhaust(old school) / T-56 6 Speed (B) / Pro 5.0 Shifter / Jack Roush Shifter Handle / Mark Martin Shift Knob(from #6) / Dynotech Alum Driveshaft #12 / F.M. 8.8 DIFF. Packed / F.M. 3.73 Gears / 31 Spline Moser Axles / 10.5 IN McLeod Clutch / Kenny Brown Subframes / Roush Std Subframes / Kenny Brown Strut Brace #2 For Sale 2001 Roush 4X4 Expedition 1 0f 6 Lariats
|
|
07-09-2003, 07:53 AM
|
||||
|
||||
|
did you disconnect the battery when you did the install If not you should disconnect it for like 5 mins to let your computer reset.
__________________
Full Sponsors: FoxMarketing.net
|
|
07-09-2003, 10:14 AM
|
||||
|
||||
|
Quote:
__________________
2001 Stage 3 Roush Premium Mineral Gray RETIRED..now residing in storage w/13k 2006 Corvette Z06 Quote:
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
