 |
|
|
|
            |
|
||||
|
||||
|
||||
05-06-2004, 08:16 AM
|
||||
|
||||
|
Billet gas cap question
I ordered the Ford OEM billet gas cap that came on the billet mustangs for my 2003 Roush. Has anyone ever installed one of these? Are they a pain in the ass, do they require drilling? Any insight would be great!!
Thanks! 
__________________
 Kenne Bell Twin Screw Intercooled Supercharger - 9 PSI pulley (11.5 PSI at the gauge) 440 HP 440 Tq  www.svtusa.com
|
|
05-06-2004, 08:40 AM
|
||||
|
||||
|
it will bolt right in.
__________________
Josh 2001 trueblue gt convertible 4r70w vortech t-trim s2 blower cams bullitt intake long tubes prochamber magnaflow 03 termi irs tuned by bob kurgan 400/358
|
|
05-06-2004, 08:47 AM
|
||||
|
||||
|
No drilling is necessary. Look up pro-fit fuel doors website for instructions. It is a tedious pain in the ass to install. Did yours come w/ a 2" long open end wrench?
__________________
P51A off-road exhaust & updated ROUSH tune  http://www.cardomain.com/ride/574408/3 360R 5,800k, Jack's sig on dash, 380 pcm, 2.8 pulley, MAC CAI, Flowmasters, S3 suspension, MAC c/c plates, Roush short throw 
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
