redfire427
Road Course Renegade

Hi Carmen,
Lee Underwood here, long time away from the forum, please tell me still do the full set of pulleys, what is the price shipped to 87114?
Thanks,
LeeU

Hey Carmen I got my blower installed. What were the questions you had on the meth kit I had Installed.
Thanks

Carmen,

I have some questions for you. I was searching Speed of Sound C pillar gauges on the forum and found a picture thread of your car. 1) When you track your car, do they obstruct your field of vision? If so, how long did it take you to adjust? 2) What do you feel are the two most important gauges? 3) I'm thinking of using a green camera filter cover to match the gauges to the Roush dash, any suggestions which gauges lend themselvesbest to filter covers? I'm thinking of just two gauges and I've modded my car after the Trak Pak, but don't like the center mounted dash gauges. I only road course track my car so far but may go to Wednesday night drags, so I'm not sure I need the shift light.
Lastly, do you have a price sheet and/or web page for your pulley bling? I will be adding the Roush CAI next season with ECM re-flash but not the smaller pulley as I'm afraid of heat soak at the track.

Thanks, Bob Campomanes, aka, Shrek427R
PS. Facebook me if you like.

PM sent Carmen. please get back at me when you get the chance. Thanks

Carmen , you have a Steeda CAI ? Did you have a tough time attaching the rubber boot ?

Dyno results......Boost up ONLY 1.01 LBS........you were correct...total boost on Dynojet 10.51 lbs Old pulley was 2.800 New 2.57
Max SPARK=31.51
Air Fuel MAF_V=1022.44
MAX POWER=479.01
MAX TORQUE=449.34
I dont have a scanner at home ,but as you stated I would be rather dissapointed.For the $125 and hour on the torque was worth it but I agree that this little huffer is all done at 10.51 lbs. I am making max HP @ 4500rpm and then it goes flat....Torque however keeps on trucking to 6400rpm....
If I can earn some cool I made the upper pulley..I will post pics

I apologize for being so rude. =)
Dr.Ruen

Whats the URL for your pulley site please

I have never tried this feature on fnsweet, so here goes. PM sent and I do love the cams.

Hello,
I'm new here...had my 2007 427r about two months and am loving it.
I traded an 2007 Shelby GT for it and I just love the Roush!!!
I noticed you have ford racing hot rod cams in yours.
A local shop here told me that would be about $2,500 installed, I was just wondering if that's about right and also I know comp. cams makes a no springs required cam that "drops in" with no additional tuning required but I don't think you can here any difference once installed and that's what I'm wanting is the sound of a good cam, so does the ford racing cam offer what I'm looking for??
Thanks