01 Front lower Roush Fascia Valance

[stage2ragtop]

Does anyone have any suggestions on how to keep the sides of the front fascia glued on? The roush front fascia on my 01 stage 2 is coming loose on the sides and now there is a gap between the original GT bumper and the Roush ad-on valance. It looks as if it was only held on with 2 sided tape???? I know there is 2 bolts in the middle front, and then the two screws on each side in the wheel well that hold it on, but it looks as if the rest is held on with 2 sided tape. Frankly it looks like crap!!!! Anyone have any suggestions? Thanks

[mln385]

The earlier models were held on with screws from the inside as well as the 3m tape.

Mine is an April build 01 and has both, if you use screws watch where you put them so the don't go thru the valance.

[stage2ragtop]

I took my bumper off last night and mine is only held on with the 3M tape. Is yours screwed on the small inner lip(where the tape is applied) to the GT bumper from the inside? Must have to use real short screws. Thanks for the info

[mln385]

Originally Posted by stage2ragtop

I took my bumper off last night and mine is only held on with the 3M tape. Is yours screwed on the small inner lip(where the tape is applied) to the GT bumper from the inside? Must have to use real short screws. Thanks for the info

Yes there is about 8 per side and 1 in the center. I think they are 3/8 of an inch long and #8'S

The tape will work though it is all in the prep. Get the adhesion promoter and apply while 70 or better.Be sure to scuff the area where the tape is applied first.