moddified upgraded brake Q'S!

[Bryan]

ok so eventuly my pads on my front's are gona go out, and bye then ima need new rotors to cuz its about that time. i wanta upgrade to 13's cobra rotors, and there are hella good packages out there for reasonable prices but i kind of wanted to put together my own with crosdrilled/ sloted rotors.... so my Q is besides the calipers, 13' rotors, and pads what kind of mounting hardware do i need?

[Blkstg2x]

Nothing different for the front 13" rotors...plus I would recommend purchasing a kit of some kind with Stainless brake lines as well for the front. As for the rear, if you decide to do 13" rotors, most brands come with the relocation bracket required to make the swap possible. It's just part of the 13" rotor kits for the rear. The rear will run you right around $250 for either Baer or Brembo. Good luck with the swap and keep us up to date!

[Roush2960]

Part needed for trh 13" front change will be :

Calipers: Bullitt/cobra/etc..are all from PBR and are the same caliper.
good source is. diskbrakesrus.com

Rotor's: If you are going to track you car at all DON'T GET Cross dirlled. They will develope crack's at the drill holes. Stay slotted or plain if you plan to track the car. Other then that Brembo,Bear or Power slot's are great.

Steel braided lines can be had from BFgoodrich or Russel.

Also if your disk and rotor are this old then I wold also suggest you flush out your fluids. Go with a high temp DOT3 fluid.

./M@